Skip to content
English
  • There are no suggestions because the search field is empty.

Can-Am X3 2 Step Launch Control Flash — Tuning Guide

Can-Am · Maverick X3 · SKU 005FC0001


Installation

1
To operate launch control, the following conditions must be met: Stationary position 2500 RPM) vehicle is not creeping forward.
  • The vehicle must be.
  • The launch switch must be pressed to the up.
  • Belt engagement must be above 2300 RPM (preferably.
  • The brake must be depressed – it is best to hold the brake hard so if the belt engages, the.
  • The gas pedal must be pressed 100%.
2
This will cause the vehicle to enter “Staging”. Staging allows you to build boost prior to launch. Boost pressure will climb up to 8lbs during staging within 3 seconds. Holding the vehicle in staging longer will not make it build more boost. It will plateau and hold. When the brake is released, the vehicle will come out of staging and will run normally. This will cause the vehicle to accelerate MUCH faster than a non-launch equipped vehicle – be prepared.
3
Hotter temperatures and higher elevation may degrade the amount of boost that can be built with the 2300 rpm rev cut. More rpm and boost target options will be added in the future for racing applications.
4
It is very important not to hold the vehicle in staging for long periods of time as can be hard on the valvetrain. Use it sparingly. EVP bears no responsibility any damage to the engine and/or drivetrain as the result of using this product.
5
Launch control will cause more wear and tear on your primary clutch and belt. Expect this. Although the factory primary clutch is very durable, it is possible to break the clutch with continuous hard launches. STM and other Billet clutches are more durable for racing and/or launch control equipped vehicles.

Note: This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA -certified, emission-regulations-exempt and noise- regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law. Questions: Call Evolution Powersports at (715) 247-3862.