Skip to content
English
Create a Ticket
  • There are no suggestions because the search field is empty.

Can-Am X3 Custom Age 625 Head Stud Kit 10mm — Install Guide

Can-Am · Maverick X3 · SKU 800FC0025

What's in the Box

Included parts
Custom Age 625 Head Stud Qty 1
Kit
-(8) 10mm Head Studs
-(8) 10mm Washers
Required tools
Torque Wrench

-(8) 10mm Nuts -Assembly Lube

INSTALLATION STEPS

Remove (1) factory head bolt and replace with (1) ARP 625 Head Stud 10mm. Apply supplied assembly lube to the top of the stud threads and both sides of the washer and nut. Install washer first, then thread nut onto the top of the stud - torque nut to 45 ft lbs. Be very careful not to drop anything into the engine! NOTE: Do this process one at a time for all remaining head bolts. Never loosen more than (1) head bolt without replacing and torquing with a stud. This will ensure the cylinder head gasket does not lose its seal. Once all factory bolts have been replaced with studs, torque the head according to the “REPLACEMENT” pattern and torque steps below. When all studs have been torqued to the final value, re-torque to the final value (3) more times.

NEW GASKET INSTALLATION

NoteIf the engine is disassembled and a new head gasket is being installed, see the “NEW GASKET” torque pattern and torque below.

Please refer to the shop manual for removal and installation and timing the camshafts.

  • To ensure proper thread engagement and accurate torque, be sure all components are clean and free of debris.
  • Use the supplied assembly lubricant on the top side of the stud and between the washer and nut.
  • Hand tightens the stud until it lightly seats into the block.
  • Install the washer and nut then torque as listed below.
Specifications 
      REPLACEMENT Torque Procedure                                            Exhaust Side
     1. Initial 55 ft lb                                                 8       1       4      5
     2. Final 80 ft lb confirm

3 TIMES

NEW GASKET Torque procedure

Specifications 
       1. Initial 30 ft lb                                                7       2       3      6
       2. Intermediate 55 ft lb
        3.Final 80 ft lb confirm 3-TIMES

Note: This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold only for use in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by and open to the public. This product is sold only in connection with machines that do not fall under state and/or federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant that the product is purchased only in connection with EPA -certified, emission-regulations-exempt and noise- regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law. Questions: Call Evolution Powersports at (715) 247-3862.